DIY Soil Health Tests

A lab test tells you what's in your soil. These three free tests show how it's working: whether it holds together, soaks up water and is full of life. All you need is a glass of water, a can and a shovel.

Get the most out of it: test the same spots in the same season each year, and log each result in Log your results below so you can watch your soil improve. Testing two spots side by side, like a garden bed and a path, makes the difference easy to see.

Structure

Slake test

Healthy soil is held together in crumbs by roots, fungi and the glue soil life makes. Those crumbs let air and water in and keep soil from crusting or washing away. Drop a dry clump in water and you can see how well it's held together.

You'll need

A clear glass or jar of water, and a walnut-sized clump of soil from the top 2 to 3 inches.

Steps

  1. Dig out a clump without breaking it up, and let it air-dry for a day. The test only works on dry soil.
  2. Fill a clear glass with room-temperature water.
  3. Gently set the clump in the water and start a timer.
  4. Watch for 5 minutes, then give the glass one gentle swirl.
  5. Score it from 1 to 5 using the table below.
What your score means
ScoreWhat you seeMeaning
1Falls apart within secondsWeak structure: crusts and erodes after rain
2Mostly falls apart within a minute
3About half is left after 5 minutesFair structure
4Mostly holds together after 5 minutesStrong structure built by roots and soil life
5Holds together, even after a gentle swirl

To improve it: keep roots growing as much of the year as you can, keep the soil covered with mulch or a cover crop, add compost, and dig as little as possible.

Water

Infiltration test (the can test)

How fast water soaks in decides whether rain feeds your plants or runs off, puddles and drowns roots. A slow result usually means compaction; a very fast one means sandy soil that dries out quickly.

You'll need

A metal can with both ends cut out (a coffee can about 6 inches across is ideal), a block of wood and a hammer, plastic wrap, a measuring cup and a timer.

Steps

  1. Clear away mulch and trim any plants down to the soil. Pick a day when the soil isn't soaked from rain.
  2. Mark a line 3 inches up from the bottom of the can. Set the wood on top and tap the can straight down to the line.
  3. Gently press the soil against the inside edge with your fingers so water can't leak down the sides.
  4. Line the can with plastic wrap and pour in 1 inch of water (see the table). Gently pull the wrap out and start the timer.
  5. Stop when the surface is just glistening, with no standing water. That first inch wets the soil.
  6. Right away, do it again with a second inch. The second time is your result.
Water for 1 inch
Can acrossWater
4 in205 mL (about 0.9 cup)
5 in320 mL (about 1.4 cups)
6 in465 mL (about 2 cups)
7 in630 mL (about 2.7 cups)
8 in825 mL (about 3.5 cups)
What the second inch means
MinutesMeaning
Under 3Very fast: water runs straight through, so water more often in smaller amounts
3 to 30Good: soaks in without puddling
30 to 60Slow: expect puddles after heavy rain
Over 60Very slow: likely compacted or heavy clay

To improve it: add organic matter, stay off beds when they're wet, and grow deep-rooted cover crops to open up compacted soil. Method adapted from the USDA-NRCS soil quality test kit.

Soil life

Earthworm count

Earthworms dig channels for water and roots and turn dead plants into rich castings. Lots of worms means soil with plenty to eat and room to live.

When

Spring or fall, when the soil is moist and cool. Worms go deep when it's hot and dry or frozen, so a summer or winter count will read low.

Steps

  1. Mark a square 1 foot by 1 foot.
  2. Dig the block out 1 foot deep and set it on a tarp or piece of cardboard.
  3. Break it apart gently by hand and count every worm. Check the sides of the hole too.
  4. Put the soil and the worms back.
  5. For a better picture, count 2 or 3 spots and log the average.
What your count means (per cubic foot)
WormsMeaning
10 or moreHealthy population
5 to 9Fair
0 to 4Low: feed them with mulch and compost, and dig less

Texture

Mason jar test

Shake soil and water in a jar, let it settle into sand, silt and clay layers, then plug the layer heights into our Soil Texture Calculator to find your soil type.

Your results

Log your results

Save each result to a plot and compare it with your last one. Test the same spots in the same season each year.

Loading…

Ready for real numbers?

DIY tests show how your soil is working. A lab test shows why, with pH, nutrients, organic matter and an exact amendment plan for your plot.